Table of Contents
Advertisement
Functions
OPERATING YOUR AIR PURIFIER
1. Press the
POWER button to turn on and
the On/Wi-Fi reset light will illuminate.
2. The air quality sensor light will illuminate,
usually starting with a blue light until it has
time to sense the air quality and then it may
change to an alternate colour.
3. To adjust how the air purifier operates,
follow the directions below.
SensAir
LIVE PURITY CONTROL
TM
• Your Breville Smart Air
a built-in air quality sensor to detect changes
to air quality in the surrounding area.
• The SensAir
indicator light around the
TM
control panel will change colours according
to the quality of the surrounding air.
Grade
Air Quality
1
Very Good
2
Good
3
Fair
4
Poor
/NIGHT MODE/
Microbe Shield
TM
RESET FILTER
The Microbe Shield
TM
and Reset Filter utilise the same button on
the control panel. Pressing the
Shield
/NIGHT/RESET FILTER button will
TM
cycle through the Microbe Shield
Modes.
Connect Purifier has
TM
Colour of Light
Blue
Yellow
Orange
Red
Mode, Night Mode
Microbe
and Night
TM
Microbe Shield
TM
• Press the
Microbe Shield
RESET FILTER button until the Microbe
Shield
indicator light illuminates to turn
TM
Microbe Shield
on.
TM
• To turn off the Microbe Shield
mode, press the Microbe Shield
MODE/RESET FILTER button again. Microbe
Shield
will turn off automatically, and the
TM
lights will remain dimmed.
• To turn off night mode, press the Microbe
Shield
/NIGHT MODE/RESET FILTER
TM
button again. All lights should return to normal.
• Alternatively, press again until the light
extinguishes to turn off this function.
Filter Reset
• When the filter reset light blinks continuously,
this is indicating that the filter needs to
be replaced.
• To reset the indicator after the filter has been
replaced, press and hold the Microbe Shield
Night Mode/Filter Reset button for 5 seconds
and the filter reset light will turn off.
Night Mode
• To turn on Night Mode, press the
Shield
/NIGHT MODE/RESET FILTER
TM
button until the night indicator light starts
to blink.
• After 10 blinks, all indicator lights on
the control panel will turn off as the unit
enters night mode and the fan speed will
automatically change to Low.
• Press any button on the control panel to
re-engage the control panel and turn off night
mode. The indicator light will extinguish.
/NIGHT MODE/
TM
during night
TM
/NIGHT
TM
/
TM
Microbe
9
Advertisement
Table of Contents
