Table of Contents
Advertisement
Mounting or Removing/Repositioning the BCI-I
Controller
To mount or remove/reposition the controller from the DIN rail,
follow the illustrated instructions below.
Figure 1. DIN rail mounting/removal
To mount device:
1. Hook device over top of DIN rail.
2. Gently push on lower half of device in the direction of arrow
until the release clip clicks into place.
To remove or reposition device:
1. Disconnect all connectors before removing or
repositioning.
2. Insert screwdriver into slotted release clip and gently pry
upward on the clip with the screwdriver.
3. While holding tension on the clip, lift device upward to
remove or reposition.
4. If repositioned, push on the device until the release clip
clicks back into place to secure the device to DIN rail.
RT-SVN13F-EN
Enclosure Damage!
Failure to follow instructions below could result in
damage to the plastic enclosure.
Do not use excessive force to install the controller on
the DIN rail. If using another manufacturer's DIN rail,
follow their recommended installation.
Pry upward
NOTICE
Slotted release clip shown from backside
13
Advertisement
Table of Contents
