Loading Door Lock - Beko WTA 10712 XSWR User Manual

You can change the auxiliary functions, speed
and temperature settings without stopping the
programme flow while the programme is running.
To do this, the change you are going to make
must be something that will be carried out after
the programme step that is running. If the change
is not suitable, relevant lights will flash 3 times.
C
INFORMATION
• If the machine does not proceed to the
spinning step, the Rinse Hold function might
be active or the automatic unbalanced load
detection system might be activated due to
the unbalanced distribution of the laundry in
the machine.

4.3.14 Loading door lock

There is a locking system on the loading door of
the machine that prevents opening of the loading
door in cases when the water level is unsuitable.
Loading door light will start flashing when the
machine is switched to Pause mode. The machine
checks the level of the water inside. If the level is
suitable, the loading door light will turn off and the
loading door can be opened within 1-2 minutes.
If the level is unsuitable, the loading door light
will remain on and the loading door cannot be
opened. If you are obliged to open the loading
door while the Loading Door light is on, you
must cancel the current programme. See
"Cancelling the programme"
Opening the loading door in case of power
failure:
C
INFORMATION
• In case of a power failure, you can use the
loading door emergency handle under the pump
filter lid to manually open the loading door.
A
WARNING!
• Before opening the loading door, make sure that
there is no water in the machine to avoid flooding.
Water may be hot and could cause scalding.
20 / EN
• Turn off and unplug the appliance.
• Open the pump filter lid.
• Remove the loading door emergency
handle behind the filter cover with a tool.
• Open the loading door by pulling the loading
door emergency handle downwards.
• Try to pull the handle downwards again
if the loading door is not opened.
• Bring the loading door emergency
handle to its original position after
opening the loading door.
4.3.15 Changing the selections
after programme has started
Switching the machine to pause mode
Press the Start/Pause to switch the machine
to pause mode while a programme is running.
The light of the current programme will flash on
the Programme Follow-up indicator, indicating
that the machine has switched to pause mode.
Also, when the loading door is ready to be
opened, the Loading Door light will turn off in
addition to the programme step light.
Washing Machine / User Manual