Remington Style Series Manual page 6

ENGLISH
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to two weeks to allow time for
your beard and skin to become accustomed to the new shaving system.
• Make sure your shaver is properly charged.
• Switch the shaver on by pressing the on/off switch.
SHAVING
• Stretch the skin with your free hand so the hairs stand upright.
• Hold the shaving head so that the foils touch your face.
• Use short linear strokes.
TRIMMING
• Slide up the trimmer release button to activate the trimmer.
• Hold the trimmer at a right angle to your skin.
• To retract the trimmer, push the top rear of the trimmer down until it locks under the
trimmer release button.
STUBBLE LOOK
Fit the stubble head guard to your shaver for a 3-day stubble look.
HEAD LOCK
Normally, the head pivots freely but its movement can be restricted by sliding the head lock
button to the locked Lposition.
BEARD TRIMMER ATTACHMENT
Use the beard trimmer without a comb fitted to trim hair close to the skin. This will trim hair
to 1 mm. Holding the blades at right angles to the skin will trim hair to 1.5 mm.
To attach a comb to the beard trimmer
1. Press the two head release buttons and remove the foil head (Fig A).
2. Fit the beard trimmer (Fig B).
3. Hook the front edge of the selected guide comb over the beard trimmer blade (Fig C).
4. Press the comb downwards until it clicks into place (Fig D).
TIPS FOR BEST RESULTS
• Always hold the shaver at right angles to the skin so that all foils are touching the skin
with equal pressure.
• Use moderate to slow stroking movements. The use of short linear motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
• DO NOT press hard against the skin in order to avoid irritation and damage to the foil
heads.
6