Table of Contents
Advertisement
12.6 Starting the wash cycle
Press
.
▶
a While the wash cycle is running, a spot of light is
projected onto the floor below the appliance door. This
light will not be visible if the appliance is installed at eye
level with the cabinet front fitted flush.
a The wash cycle has ended when no displays on the
controls are lit.
a The wash cycle has ended when the spot of light is no
longer visible on the floor.
Notes
¡ If you want to add more dishware while the appliance is
running, do not use the collecting tray as a handle for
the upper rack. You might touch the partially dissolved
tablet.
¡ You can only change a cycle in progress if you can
cancel it first.
→ "Terminating the wash cycle", Page 19
¡ To save energy, the appliance switches off
automatically 10 minutes after the end of the wash
cycle. If you open the appliance door immediately after
the wash cycle has ended, the appliance will switch off
after 4 seconds.
12.7 Interrupting the wash cycle
Press On/Off.
1.
The program is saved and the appliance switches off.
Press On/Off.
2.
Press
to resume the wash cycle.
3.
12.8 Terminating the wash cycle
To end a cycle early or to switch from one that has already
started, you will need to cancel it first.
Press
for approx. 4 seconds.
▶
a All displays light up.
a As soon as the displays are off, the residual water is
pumped out.
a The cycle is cancelled and ends after approx. 1 minute.
12.9 Switching off the appliance
CAUTION
To avoid risk of injury, always use caution when opening
the door during or following a wash cycle as hot water or
steam may escape.
Do not fully open the door until water noises have
▶
stopped and steam has subsided.
Please note the information on Preventing Material
1.
Damage → Page 6 .
Press On/Off.
2.
Basic Operation en-us
19
Advertisement
Table of Contents
