Table of Contents
Advertisement
a. Open the retaining clips of the memory slot.
Figure 31. Opening the retaining clips
b. Position the new memory module over the memory slot. Ensure that the notch
module is aligned with the key
the retaining clips completely close.
Note: Do not touch the circuit board or the contact edge of the memory module.
Figure 32. Installing a memory module
6. Reinstall the PCIe x16 graphics card if you have removed it.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 154.
Slim optical drive
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
2
in the slot. Push the memory module straight down into the slot until
1
on the memory
.
Chapter 9
Hardware removal and installation
105
Advertisement
Table of Contents
