Table of Contents
Advertisement
en operation
operation
7 Basic operation
operation
7.1 Switching on the appli-
ance
Electrically connect the appliance.
1.
→ Page 12
Note: If the appliance has been
previously switched off using the
control panel, press and hold
for three seconds.
a The appliance begins to cool.
a A warning signal sounds and the
temperature display (freezer com-
partment) and
cause the freezer compartment is
still too warm.
Switch off the warning tone using
2.
.
goes out as soon as the
a
set temperature has been reached.
Set the required temperature.
3.
→ Page 16
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
Press and hold
▶
three seconds.
16
flash be-
for
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
Press the required temperature.
▶
The recommended temperature in
the refrigerator compartment is
4 °C.
Setting the freezer compartment
temperature
Press the required temperature.
▶
The recommended temperature in
the freezer compartment is
−18 °C.
8 Additional functions
8.1 Super cooling
With Super cooling, the refrigerator
compartment cools as cold as pos-
sible.
Switch on Super cooling before pla-
cing large quantities of food.
Note: When Super cooling is
switched on, increased noise may
occur.
Switching on Super cooling
Press
▶
lights up.
a
Note: After approx. 6 hours, the ap-
pliance switches to normal operation.
Switching off Super cooling
Press
▶
.
.
Advertisement
Table of Contents
