Programming Mode - LG F1069FD4P Owner's Manual

22

PROGRAMMING MODE

PROGRAMMING MODE
: You can check machine information or change setting on Program setup, Collect Information Data,
Diagnostic Test.
There are two methods that you can enter programming mode.
how to enter Programming mode
You can enter programming mode only for Idle
state and pause state.
- Card Type
1) Insert service card.
2) Display will show
- Coin Type
1) Dissemble upper coin box key.
2) Take out the coin drop from the coin box.
3) Turn on/off the toggle switch at the back of
the coin box.
4) Display will show
- OPL Type
1) Push the Hot & Cold button at the same
time.
2) Push the Warm button 3 times.
3) Push the Start button.
4) Display will show
Coin Box Key
Coin Vault
Openings close
- coin type -
NOTE
• If you turn on the power without connecting meter case for the first time, the machine display
.
• When the machine is shipped from the factory, it is set in the coin type. You can change Card/
Coin type by button. (For more information refer to SETUP mode.)
• The machine will display PUSH for OPL type
• Price setting varies by country
• Set your country from
• After EEPT, reset your country (Default country is EUK)
.
.
.
Insert Debit Card
- card type -
mode (Refer How to enter the
how to use button
You can change Washer vend price, cycle time
and Cycle parameters, etc.
Press Button
Move to upper level or
Hot
Comes back to Idle State
Move to the mode in the
Warm
Move to the modes in the
Cold
Start Enter the selected mode
)
Description
same level (+)
same level (-)
- OPL type -