Table of Contents
Advertisement
www.ti.com
Jumper
Default
L3
0-Ω R
R30
open
L4
0-Ω R
R42
open
C16
Installed
R41
Installed
C17
Installed
2
Software Control
2.1
Installation Instructions
•
Open folder named ADS540x_Installer_vxpx (xpx represents the latest version, which is 1.3 at the time
of this writing)
•
Run Setup.exe
•
Follow the on-screen instructions
Once installed, launch by clicking on the ADS540x_GUI_vxpx program in Start → Texas Instruments
•
ADCs
•
When plugging in the USB cable for the first time, the Found-New-Hardware-Wizard prompts for the
installation of the USB drivers.
– When a pop-up screen opens, select Continue Downloading.
– Follow the on-screen instructions for installing the USB drivers
– If needed, access the drivers directly in the install directory
2.2
Software Operation
The software allows programming control of the ADC device. The front panel provides a tab for full
programming of the register map of the ADS540x. The GUI tabs provide a convenient and simplified
interface to the most used registers of each device.
SLAU450 – July 2012
Submit Documentation Feedback
Table 2. Surface Mount Jumpers (continued)
Description
Connects SMA Channel B + input to input transformers
Connects SMA Channel B – input to GND
Connects SMA Channel B – input to bypass input transformers
Connects Channel B + input bypassing transformers
Connects Channel B + input from transformers
Connects Channel B – input bypassing transformers
Connects Channel B – input from transformers
Copyright © 2012, Texas Instruments Incorporated
ADS540x and ADS54T0x Evaluation Module (EVM)
Software Control
7
Advertisement
Table of Contents
