Advertisement
To use the mode button, press, and keep pressed, the mode button on the access point during the boot
cycle. Wait until the status LED changes to Amber. During this, the AP console shows a seconds
counter, counting the number of seconds the mode button is pressed. Then:
• To reset the AP to the default factory-shipped configuration, keep the mode button pressed for less
than 20 seconds. The AP configuration files are cleared.
This resets all configuration settings to factory defaults, including passwords, encryption keys, the
IP address, and the SSID. However, the regulatory domain provisioning is not reset.
• To clear the AP internal storage, including all configuration files and the regulatory domain
configuration, keep the mode button pressed for more than 20 seconds, but less than 60 seconds.
The AP status LED changes from Amber to Red, and all the files in the AP storage directory are
cleared.
If you keep the mode button pressed for more than 60 seconds, the mode button is assumed faulty and
no changes are made.
24
Advertisement
