Self-Diagnosis; Temp Sensor & Heater Check - Samsung NV51 5512 Series Installation Manual

Built-in electric wall oven
Table of Contents

Advertisement

Available languages

Available languages

Self-diagnosis

Temp sensor & Heater check
1.
After connecting the power, check if the display works properly.
2.
Remove all accessories (Flat-Rack...etc.) from inside of the oven cavity.
3.
You cannot proceed with self-diagnosis if the oven cavity is hot or the door is
open.
In this case, "Hot or door" message appears on the display.
4.
To start self-diagnosis, press both Hidden Keys simultaneously for 5 seconds.
Refer to the table below for the hidden keys for each model.
Model
NV51*5*****
Control panel
Hidden Key
Keep Warm + "9"
5.
If there is no error, 'PASS' appears on the display with an alert sound.
6.
If there is an error, following message appears on the display with an alert
sound.
Model
Upper Broil
Upper Bake
Feature
Lower Broil
Lower Bake
7.
If an error occurs, contact a Samsung service center for further service.
NOTE
If you see any other error messages that are not listed above, please contact a
Samsung service center. call e.g. 1-800-SAMSUNG (726-7864)
Install_NV51T5512SS_AC_DG68-00862B-00_EN+MES+CFR.indb 15
All models
Error code
Remark
H-2
Double/Single Oven
H-1
H-4
Double Oven Only
H-3
Memo
English 15
2020-04-29
8:10:21

Advertisement

Table of Contents
loading

Table of Contents