Self-Diagnosis; Temp Sensor & Heater Check - Samsung NQ70T5511DG Installation Manual

Built-in microwave combination oven
Hide thumbs Also See for NQ70T5511DG:
Table of Contents

Advertisement

Available languages

Available languages

Self-diagnosis

Temp sensor & Heater check
1.
After connecting the power, check if the display works properly.
2.
Remove all accessories (Gliding Rack, Flat-Rack, Smart Divider...etc.) from
inside of the oven cavity.
You cannot proceed with self-diagnosis if the oven cavity is hot or the door is
3.
open.
In this case, "Hot or door" message appears on the display.
4.
To start self-diagnosis, press both Hidden Keys simultaneously for 5 seconds.
Refer to the table below for the hidden keys for each model.
Self-diagnosis takes approximately 4 ~ 5 minutes.
Model
Control panel
Hidden Key
14 English
Install_NQ5300R_NQ70R5511DG_AA_DG68-01149A-04_EN.indd 14
NQ70*5***D*
Keep Warm + "9"
5.
If there is no error, 'PASS' appears on the display with an alert sound.
6.
If there is an error, following message appears on the display with an alert
sound.
Model
Error code
Lower Broil
H-4
Feature
Lower Bake
H-3
7.
If an error occurs, contact a Samsung service center for further service.
NOTE
If you see any other error messages that are not listed above, please contact a
Samsung service center. call e.g. 1-800-SAMSUNG (726-7864).
NQ70*5***D*
Remark
Lower Oven Only
11/11/2019 6:07:32 PM

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nq70 5 d seriesNq70t5511ds

Table of Contents