Table of Contents
Advertisement
2.2
Connecting the cables
Connect the cables according to the following instructions:
•
To connect the power cable: Connect the Type-C plug of the adapter to the
monitor's USB Type-C port, and connect the 3-pin receptacle of the adapter to
the power cord. Then connect the power cord to a power outlet.
To connect the HDMI/USB Type-C cable:
•
a.
Plug one end of the HDMI/USB Type-C cable to the monitor's HDMI/USB
Type-C port.
b.
Connect the other end of the HDMI/USB Type-C* cable to your device's
HDMI/USB Type-C port.
It is suggested to use USB certified Type-C 4K/ support 4A (or up to 4A) cable.
If the signal source supports DP Alt mode, all video, audio and data signal can
be transmitted.
To use the USB upstream (for Touch / Pen) function: Use an USB Type-C
•
cable and plug on end of the Type-C connector to the monitor's USB Type-C
port as upstream and the other end to your computer's USB Type-C port. Or use
an USB Type-C to Type-A cable, plug the Type-C connector to the the monitor's
USB Type-C port as upstream and the Type-A connector to your computer's
USB Type-A port. Make sure your computer is installed with the latest Windows
10/11 operating system. That will enable the USB ports on the monitor to work.
When these cables are connected, you can choose the desired signal from the
Input Select item in the OSD menu.
To connect USB Type-C cable only: Connect the other end of USB Type-C cable
•
from your notebook to PA169CDV Type-C full function port (notebook/devices
requires DisplayPort Alt Mode and at least 15W PD power output).
2-2
Chapter 2: Setup
Advertisement
Table of Contents
