Oscillating Systems With One Pzt-Rings - BANDELIN SONOREX RK 31 Service Instructions Manual

4. 5. 2. 3 Oscillating systems with one PZT-ring
Replacement parts: 1 PZT-ring, diam. 38mm, SW 004
hexagon socket head screw
steel bush
insulating disc
white ring
transducer wire
blue
Cu-Be disc
TS-0152-LM
thread facing up
PZT-ring
marking
facing up
Cu-Be disc
TS-0152-LM
thread facing up
*
RK 100 SH from serial no. 192 178 xxx (onwards): an epoxy glass fibre disc is attached instead of the white ring IS 013.
If the oscillating system is damaged, the entire set of replacements parts must be used. If necessary re-adjust the generator.
1 insulating disc* IS 013 white ring
2 Cu-Be disc with soldered squarehead screw, TS-0152-LM (Cu-Be = copper-
beryllium)
2 angles, RK 539
2 spring washers, DIN 127 B 4, NU 101
2 nuts, DIN 934 M 4, NM 303
2 insulating bushes, 11 × TS-0190, 1 × TS-0153 (to be used according to the
existing oscillating system)
1 hexagon socket head screw:
insulating bush
TS-0190
height in mm
steel bush
17
22
cone
insulating bush
TS-0153
18
hexagon socket head screw
NS 342
DIN 912-M 10 × 45
NS 347
DIN 912-M 10 × 50
hexagonal nut
DIN 934 M 4 (brass)
spring washer
DIN 127 B 4
angle
RK-539
transducer wire
red
squarehead screw
RK-538 M 4 × 8,
soldered in TS-0152