Element Operation - Wolf 2 Series Technical Service And Parts Manual

Operation Mode (continued)
Press & Hold [-] pad for individual Heating Zone
• After .5 sec -6 LEDs light up and power level lowers
to 4
• After 1 sec. -4 LEDs light up and power level lowers
to 3
• After 1.5 sec -2 LEDs light up and power level lowers
to 2
• After 2 sec -1 LEDs light up and power level lowers
to 1
Press & Release [+] pad for individual Heating Zone
• 8 Flashing LEDs light up and power level goes to 5
• Any addition presses of the [+] key will result in
stepping up a level and the corresponding LEDs
lighting up.
Press & Release [-] pad for individual Heating Zone
• 8 fl ashing LEDs light up and power level goes to 5.
• Any additional presses of the [-] key will result in stepping down a level and the corresponding LEDs deactivated.
Deactivating a Heating Zone.
Press [OFF ON] on active Heating Zone
• Sets Power level of that heating zone to 0 and turns off all the LEDs. (See Figure 3-11)
ELEMENT OPERATION: (with hob's inner element already active)
Dual Element Operation
• Action: Press [ZONE 2] pad to activate outer element Hob
• Result: Power will be applied to outer element at same level as inner zone and [ZONE 2] LED goes ON.
• Action: Press [ZONE 2] pad again for the same Hob
• Result: Power removed from dual element (power remains ON for Single element) and [ZONE 2] LED goes OFF.
NOTE: Inner Zone may dim when outer Zone is activated due to limits on the maximum output of element.
Triple Element Operation
• Action: Press [ZONE 2] pad for Triple Element individual hob
• Result: Power will be applied to center element at same level as inner zone and [ZONE 2] LED goes ON
• Action: Press [ZONE 2] pad again for same Hob
• Result: Power removed from center element (power remains ON for single element) and Zone LED goes OFF.
• Action: Press [ZONE 3] pad for Triple Element individual Hob
• Result: Power will be applied to center and outer elements and Zone 2 and 3 LEDs go ON
• Action: Press [ZONE 3] pad again for same Hob
• Result: Power removed from outer element (but power remains ON for Single and Dual Elements) and Zone 3 LED
goes OFF (Zone 2 LED remains ON)
• Action: Press [ZONE 2] pad for same Hob.
• Result: Power removed from center element (Power remains ON for single element) and Zone 2 LED goes OFF.
NOTE: Inner Zones may dim when outer Zone is activated due to limits on the maximum output of element.
Bridge Element Operation
• Action: Press [BRIDGE] pad for Bridge Element (one or both bridge linked hobs is currently on, if neither hob is on,
unit will provide an error tone and no further action will be taken)
• Result: Power applied to Bridge element BRIDGE LED goes ON; both front and rear hobs will automatically take
on the current lowest hob setting. (i.e. if both hobs are on, the rear is on high, the front is on medium, a press of
the [BRIDGE] key will turn on the bridge elements and the system (all three elements) will take on the medium
setting. If both hobs are on high and the [BRIDGE] key is touched, the system will take on the high setting).
Electric Cooktop -2
3-7
Electronic Control
MELT OFF ON
CLEAR
HOT
Figure 3-11 Deactivating a heating zone.
HIGH
OFF