LG WD-16220FD Service Manual page 31

ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER ASSEMBLY
Rotor
Bolt
Hinge
(FRICTION DAMPER ASSEMBLY)
Clean the drain pump filter
1. Open the lower cover
cap ( ) by using a
coin. Turn the drain
plug ( ) to pull out
the hose.
100
1
(ROTOR ASSEMBLY)
(1)
(STATOR ASSEMBLY)
Damper
2. Unplug the drain plug ( ),
allowing the water to flow out. At
this time use a vessel to prevent
water flowing on to the floor. When
water does not flow any more, turn
the pump filter ( ) open to the left.
Remove the BACK COVER.
Unscrew the bolt to pull out the ROTOR ASSEMBLY.
Disconnect the wiring connector.
Unscrew 6 bolts from the STATOR.
Remove the BODY FRAME.
(Only 1400 rpm models)
Note : Hook of connector (1) is on the backside
Pull out the HINGE, pressing its snap.
Do not use the pulled out HINGE again
It may be taken off during operation.
2
3
30
3. Remove any foreign material
from the pump filter ( ). After
cleaning, turn the pump filter ( )
clockwise and insert the drain
plug ( )to the original place.
close the lower cover cap.
3
2