HP ProDesk 600 G2 Hardware Reference Manual page 30

9. Slide the optical drive through the front of the chassis all the way into the bay so that it locks in place
(1), and then connect the power cable (2) and data cable (3) to the rear of the drive.
10. Connect the opposite end of the data cable to one of the light blue SATA connectors on the system
board.
NOTE:
connectors.
11. Replace the front bezel if it was removed.
12. Replace the computer access panel.
13. If the computer was on a stand, replace the stand.
14. Reconnect the power cord and any external devices, and then turn on the computer.
15. Lock any security devices that were disengaged when the access panel was removed.
24 Chapter 2 Hardware upgrades
Refer to System board connections on page 12 for an illustration of the system board drive