Yamaha ARIUS YDP-184 Owner's Manual page 105

5-1.
Insert the plug of the pedal cord into the
pedal connector.
Insert the pedal cord securely
until the metal part of the cord
plug disappears from view.
Otherwise, the pedal may not
function properly.
5-2.
Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
5-3.
Use a vinyl tie to take up any slack in the
pedal cord.
5-4.
Connect one end of the power cord to the
AC adaptor.
5-5.
Insert the DC plug of the AC adaptor into
the DC IN jack.
6.
Set the adjuster.
Rotate the adjuster until it comes in firm contact
with the floor surface.
7.
Attach the headphone hanger.
Use the two thin screws (4 × 10 mm) to attach the
hanger as shown in the illustration.
Transporting
If you move to another location, you can transport
the instrument along with other belongings. You can
move the unit as it is (assembled) or you can
disassemble the unit down to the condition it was in
when you first took it out of the box. Transport the
keyboard horizontally. Do not lean it up against a
wall or stand it up on its side. Do not subject the
instrument to excessive vibration or shock. When
transporting the assembled instrument, make sure all
screws are properly tightened and have not been
loosened by moving the instrument.
Keyboard Stand Assembly
105
YDP-184 Owner's Manual