Midland HP108 Manual page 32

DCS code (I/N) frequency chart
017 073 165 263
023 074 172 265
025 114 174 266
026 115 205 271
031 116 212 274
032 122 223 306
036 125 225 311
043 131 226 315
047 132 243 325
050 134 244 331
051 143 245 332
053 145 246 343
054 152 251 346
065 155 252 351
071 156 255 356
072 162 261 364
SCAN
HP108/408 can scan the previously set channels for activity.
There are three types of scanning:
› SE: the radio stops on a busy channel and exits from the scanning mode.
› TO: Time-operated scan: the scanning will stop when the radio detects a
signal on a busy channel and will resume after 5 seconds even though the
signal is still present.
› CO: Carrier-operated scan: the scanning will stop on an active channel
till the signal is detected. It will resume scanning after 2 seconds when the
channel is no longer active.
Note: Scanning is interrupted by pushing MONITOR and resumes work-
14
ing when you release the button.
Selecting the scanning type
365 466 654
Press F
371 503 662
To enter the menu, press F
411 506 664
type of scanning amongst SE, CO or TO.
412 516 703
Confirm your selection by pressing F
413 523 712
Scanning the stored channels
423 526 723
To start scanning, press F
431 532 731
The scanning starts from the channel currently in use.
To invert the scanning direction, press ▲/▼.
432 546 732
To exit from this setting, push F
445 565 734
Note: The scan can be done between 2 channels at least.
446 606 743
Before starting the scan feature, the squelch must be deactivated.
452 612 754
Scanning exclusion
454 624
Some memory channels can be excluded from the scanning.
455 627
Procedure:
462 631
› Select the channel to exclude.
464 632
› Press F
465 645
Note: in this case, PRI disappears from the display.
All the channels that do not show PRI on the display are excluded from the
scanning.
Keypad lock
To avoid accidentally changing the frequency or the radio settings, the keypad
can be locked.
Press the F
When this function is enabled, the display shows
Editing from the keypad
Edit the channel number by pressing the keypad buttons (3 digits max, for
example '003'). The radio will show the number of the channel.
, 9 sel and select menu 19 (SCN MD).
and by means of the ▲/▼ buttons, choose the
or PTT or 9 sel.
and 3 scan.
or PTT.
and 0 lock to set this feature.
button for 2 seconds to activate/deactivate the keypad lock.
.