Table of Contents
Advertisement
8 8 8 . . . 1 1 1 H H H o o o w w w t t t o o o e e e n n n t t t e e e r r r i i i n n n t t t o o o t t t h h h e e e f f f a a a c c c t t t o o o r r r y y y m m m o o o d d d e e e l l l
8.1 How to enter into the factory model
1. You can press "source-2-5-8-0" or "Menu-8-8-9-3" to go into factory setting.
Presse the key "exit" to shut the factory setting.
content:
1: ADC setup: set ADC value of YUV,VGA. It can also be auto-set. Adopt 100%
color bar to yuv and Checkerboard signal to vga.
2:Adjust the brightness and contrast ratio of each signal, which do not affect the
value of user's menu.
3: adjust the color temperature and white balance of each signal source.
4: SSC to adjust the spectrum for passing the EMC test.
5:special set
1)2hour off-- for Aging test
2)WDT --watch dog
3)white pattern --set pure color output for the panel, used at the checking and
aging test for panel.
4)reset
5)set the recorder
6)set power-on screen display.
6:QMAP adjust :adjust color quality.
7:PEQ set sound EQ
8:sw information: to check the sofeware information
9:UART DEBUG : Access to serial port and connect a computer if set to HK.
10:BMTEST :cpu check the CPU
The last line is SW Ver.No
- 48 -
Service Manual
Model No.:
Advertisement
Table of Contents
