Maintenance, Storage, And Safety; Safety Decals - Ferris FS3200 Operator's Manual

Maintenance, Storage, and Safety

• Always observe safe refueling and fuel handling practices
when refueling the unit after transportation or storage.
• Always follow the engine manual instructions for storage
preparation before storing hte unit for both short and long
term periods.
• Always follow the engine manual instructions for proper
start-up procedures when returning the unit to service.
• Never store the machine or fuel container inside where
there is an open flame, such as in a water heater. Allow
unit to cool before storing.
• Do not store fuel near flames or drain indoors.
• Keep all hardware tight and keep all parts in good
working condition. Replace all worn or damaged decals.
• Never tamper with safety devices. Check their proper
operation regularly.
• Disengage spreader spinner, set parking brake, stop
engine and remove key or disconnect spark plug wire.
Wait for allmovement to stop before adjusting, cleaning,
or repairing.
• Clean grass and debris from moving parts, drives,
mufflers, and engine to prevent fires. Clean up oil or fuel
spillage.
• Let engine cool before storing and do not store near
flame.
• Stop and inspect the equipment if you strike an object.
Repair, if necessary, before restarting.
• Park machine on level ground. Never allow untrained
personnel to service machine.
• Use jack stands to support compnents when required.
• Carefully release pressure from components with stored
energy.
• Disconnect battery or remove spark plug wire before
making any repairs. Disconnect the negative terminal
first and the positive last. Reconnect positive first and
negative last.
• Keep hands and feet away from moving parts. If possible,
do not make adjustments with the engine running.
• Charge batteries in an open, well-ventilated area,
away from sparks and flames. Unplug charger before
connecting or disconnecting from battery. Wear protective
clothes and use insulated tools.
• Check brake operation frequently. Adjust and service as
required.
• Use only factory authorized replacement parts when
making repairs.
• Always comply with factory specifications on all settings
and adjustments.
• Only authorized service locations should be utilized for
major service and repair requirements.
• Never attempt to make major repairs on this unit unless
you have been properly trained. Improper service
procedures can result in hazardous operation, equipment,
damage, and voiding of manufacturer's warranty.
8
WARNING
Units with hydraulic pumps, hoses, or motors: Hydraulic
fluid escaping under pressure may have suffcient force to
penetrate skin and cause serious injury. If foreign fluid is
injected into the skin it must be surgically removed within
a few hours by a doctor familiar with this form of injury, or
gangrene may result. Keep body and hands away from
pin holes or nozzles that eject hydraulic fluid under high
pressure. Use paper or cardboard, and not hands, to search
for leaks. Make sure all hydraulic fluid connections are tight
and all hydraulic hoses and lines are in good condition
before applying pressure to the system. If leaks occur, have
the unit serviced immediately by your authorized dealer.
WARNING
Stored energy device: Improper release of springs can
result in serious personal injury. Springs should be removed
by an authorized technician.
• Always disengage the spreader spinner and close the
hopper gate before performing maintenance or storing.
• Empty the fertilizer hopper before lifting or tilting the
machine for maintenance or storage.

Safety Decals

Before operating your unit, read the safety decals. The
cautions and warnings are for your safety. To avoid a
personal injury or damage to the unit, understand and follow
all safety decals.
WARNING
If any safety decals become worn or damaged, and
cannot be read, order replacement decals from your
local dealer.
ferrismowers.com