Advertisement
Figure 6: Crimp ring terminal
1
Crimp the surge protector terminal ring to the ground cable.
Re-attach the crimped terminal with ground cable to the surge
protector.
Attach the cable to the surge protector (see below).
Figure 7: Attach the cable
Remove the split washer and hex nut from the surge protector.
Slide the gasket onto the surge-protector where the split
washer and hex nut were removed.
Identify the enclosure used and the location of the antenna
hole.
IMPORTANT NOTE: The 8 AH, 13 AH, 16 AH, and 26 AH
batteries fit in the 6410 enclosure with the antenna surge
protector installed.
6 | WI-FI ANTENNA KIT | 2106123MNAD
Advertisement
