Axis Q6052 User Manual page 22

AXIS Q6052 PTZ Dome Network Camera
Video and Audio
Note
The padlock icon
information about what settings need to be changed to unlock the feature.
About capture modes
The selected capture mode enables different resolutions and frame rate in the product. The Americas usually use NTSC, whereas
most other parts of the world use PAL.
Capture mode
PAL
NTSC
How to change capture mode
1. Go to Setup > Video & Audio > Camera Settings.
2. Select the new capture mode.
3. Click Save.
To change resolution, go to Setup > Video & Audio > Video Stream.
Image Appearance
To change Image Appearance go to the menus under Setup > Video & Audio > Camera Settings.
Increasing the Color level increases the color saturation. The value 100 gives maximum color saturation and the value 0 gives
minimum color saturation.
The image Brightness can be adjusted in the range 0–100, where a higher value produces a brighter image.
Increasing the Sharpness can increase bandwidth usage. A sharper image might increase image noise especially in low light
conditions. A lower setting reduces image noise, but the whole image will appear less sharp.
White Balance
To change this setting go to Setup > Video & Audio > Camera Settings
White balance is used to make colors in the image appear the same regardless of the color temperature of the light source. The Axis
product can be set to automatically identify the light source and compensate for its color. Alternatively, select the type of light
source from the drop-down list. For a description of each available setting, see the online help
shows that the feature is locked because of other settings. Point the mouse over the padlock to get
Maximum frame rate
50 fps
60 fps
Resolution
D1
4CIF
2CIF
CIF
QCIF
D1
4CIF
2CIF
CIF
QCIF
22
720 x 576
704 x 576
704 x 288
352 x 288
176 x 144
720 x 480
704 x 480
704 x 240
352 x 240
176 x 120
.