Toto Connelly TS221T Installation And Owner's Manual page 4

2. Remove the plaster guard from
the valve.
3. Measure the distance from the finished wall
to the top of the trim adapter. Compare that
distance with the table below to determine
which stop to use:
X
Less than
2-1/16"
(53mm)
2-1/16"
(53mm)
or more
* Pre-installed on valve
4. Remove the trim adapter.
Install the proper length
temperature limit stop,
making sure that the
alignment marks on the
valve body and limiter line
up (roughly at 1 o'clock
position).
Reinstall the trim adapter.
Installation Procedure (continued)
Use
Long Temperature
Limit Stop
1.5" (37.5mm) *
Short Temperature
Limit Stop
1" (25mm)
Trim Adapter
Plaster Guard
Trim Adapter
Long Stop
4
Valve
(X)
Finished Wall
Short Stop
Alignment Alignment
Mark on Stop Mark on Valve