Dell Inspiron 3020 Service Manual page 69

Table 16. System setup options—Pre-boot Behavior menu
Pre-boot Behavior
Warnings and Errors
Warnings and Errors
Fastboot
Fastboot
Extend BIOS POST Time
Extend BIOS POST Time
Table 17. System setup options—Virtualization menu
Virtualization
Intel Virtualization Technology
Enable Intel Virtualization Technology
(VT)
VT for Direct I/O
Enable Intel VT for Direct I/O
Table 18. System setup options—Performance menu
Performance
Multi-Core Support
Active Cores
Intel® SpeedStep
Enable Intel SpeedStep Technology
C-States Control
Enable C-State Control
Intel Turbo Boost Technology
Enable Intel® Turbo Boost Technology
Selects an action on encountering a warning or error during boot.
Default: Prompt on Warnings and Errors. Stop, prompt, and wait for user input
when warnings or errors are detected.
NOTE: Errors deemed critical to the operation of the computer hardware
will always halt the computer.
Configures the speed of the UEFI boot process.
Default: Thorough. Performs complete hardware and configuration initialization
during boot.
Configures the BIOS POST (Power-On Self-Test) load time.
Default: 0 seconds
Enables the computer to run a virtual machine monitor (VMM).
Default: ON
Enables the computer to perform Virtualization Technology for Direct I/O (VT-
d). VT-d is an Intel method that provides virtualization for memory map I/O.
Default: ON
CPU core disabling is not supported with current BIOS version. Changes the
number of CPU cores available to the operating system. The default value is
set to the maximum number of cores.
Default: All Cores
Enables or disables the Intel SpeedStep Technology to dynamically adjust
processor voltage and core frequency, decreasing average power consumption
and heat production.
Default: ON
Enables or disables the CPU's ability to enter and exit low-power states.
Default: ON
Enabled or disabled the Intel TurboBoost mode of the processor. If enabled,
the Intel TurboBoost driver increases the performance of the CPU or graphics
processor.
System setup 69