Night Owl FTD2 Series User Manual page 13

Perform the following steps to get the rest of the hardware setup!
1. Plug one end of the included Ethernet cable
into the LAN port on the back of the DVR.
NOTE: Night Owl recommends
connecting to the Internet for
the best user experience.
2. Plug the other end of the Ethernet cable into
a port on the back of your router / network
access point.
NOTE: As long as your DVR is hardwired
using Ethernet cabling, you can
connect to any working network
access point. See your product
manual for more details.
3. Connect the end of the camera's cable to
the end of a video / power cable labeled TO
CAMERA ONLY.
IMPORTANT: BEFORE installing, connect
and test each camera locally to
confirm they function properly.
4. Connect the video / power cable labeled TO
DVR ONLY to an open video input on the DVR.
NOTE: Make sure you twist and lock
BNC connectors.
RESET
LAN1 LAN2 LAN3
Router / Network Access Point
(Not Included)
From Camera Video / Power Cable
LAN4 WAN
7