GMC Sierra Denali 2500HD 2014 Owner's Manual page 287

GMC Sierra Denali 2500HD and 3500HD (GMNA-Localizing-U.S./Canada-
7142957) - 2014 - CRC 1st Edition - 3/28/13
A. Chassis harness connector
B. Release tab
4. Feed the wiring harness through
the pickup box, then plug the
camera connectors together to
prevent contamination.
5. Remove the tailgate. See
Tailgate on page 2-8 for more
information.
6. Reinstall the license plate.
Reverse this procedure to reinstall
the RVC and make sure the
grommet and connection are
secure.
When the System Does Not
Seem To Work Properly
The RVC system might not work
properly or display a clear image if:
The RVC is turned off. See
Turning the RVC System On or
Off earlier in this section.
It is dark.
The sun or the beam of
headlamps is shining directly
into the camera lens.
Ice, snow, mud, or anything else
builds up on the camera lens.
Clean the lens, rinse it with
water, and wipe it with a soft
cloth.
The back of the vehicle is in an
accident, the position and
mounting angle of the camera
can change or the camera can
be affected. Be sure to have the
camera and its position and
mounting angle checked at your
dealer.
Black plate (53,1)
Driving and Operating
The RVC system display in the
rearview mirror may turn off or not
appear as expected due to one of
the following conditions. If this
occurs the left indicator light on the
mirror will flash.
A slow flash may indicate a loss
of video signal, or no video
signal present during the reverse
cycle.
A fast flash may indicate that the
display has been on for the
maximum allowable time during
a reverse cycle, or the display
has reached an Over
Temperature limit.
The fast flash conditions are
used to protect the video device
from high temperature
conditions. Once conditions
return to normal the device will
reset and the green indicator will
stop flashing.
9-53