Table of Contents
Advertisement
Fault
Appliance cannot be
switched on or operated.
Appliance does not start.
Programme starts
automatically.
Door does not open
automatically at the end of
the Eco 50° programme.
The door is difficult to
open.
* depending on the features of your dishwasher
Reason
Malfunction.
The mains fuse has tripped.
Power cord not inserted.
The appliance door has not been
shut properly.
Pause function is active. *
You did not wait until programme
ended.
Eco drying deactivated.
Button lock/childproof lock is
activated. *
Eco 50° programme not
selected.
Additional functions selected.
Intensive drying switched on.
Door is not set correctly.
Door and door seal dirty.
Wrong screws used to adjust the
door gap. If excessively long
screws are screwed in, they may
deactivate Eco drying.
Safety device switches the Eco
drying function off. A technical
fault has probably occurred.
Child-proof lock is activated.
Fault, what to do? en
Remedial action
Disconnect appliance from the power
supply; pull out the mains plug or switch
off the fuse. Wait at least 5 seconds, then
connect the appliance to the power
supply.
Check mains fuse.
Ensure that the power cord is plugged all
the way into the back of the appliance and
into the socket. Check that the socket
functions.
Close the door.
Press the Start button P. *
Perform reset.
Activate Eco drying. ~ "Operating the
appliance" on page 27
Deactivate button lock/childproof lock. *
~ "Button lock" on page 8
Select Eco 50° programme.
Deselect additional functions.
Switch off intensive drying.
Set the door correctly with the aid of the
installation instructions so that the door
gap is at least 70 mm - 100 mm.
Clean door and door seal with a damp
cloth and a little washing-up liquid.
To adjust the door gap, use screws which
have a max. size of ø 4X30 (included in
the product package, see installation
instructions).
Call the after-sales service.
Deactivate childproof lock.
43
Advertisement
Table of Contents
