Table of Contents
Advertisement
en Fault, what to do?
Fault
Utensils not dry.
Plastic utensils not dry.
Cutlery not dry.
Appliance interior wet after
wash cycle.
* depending on the features of your dishwasher
38
Reason
Not enough rinse aid in the
dispenser, or none at all.
Programme without drying was
selected.
Water collecting in depressions
on the utensils and cutlery.
The combined detergent used
has a poor drying performance.
The extra drying option to
increase drying was not
activated.
Utensils were removed too early
or drying process had not ended
yet.
The eco rinse aid used has a
limited drying performance.
Door does not open automatically
at the end of the Eco 50°
programme. Door gap is not set
correctly.
Special properties of plastic.
Cutlery not arranged properly in
the cutlery basket.
Cutlery not arranged properly in
the cutlery drawer.
No appliance fault.
Remedial action
Refill rinse aid.
Select programme with drying.
~ "Overview of programmes"
on page 24
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
Use different combination detergent with
better drying performance. Use of rinse
aid also improves the drying performance.
Activate intensive drying. ~ "Operating
the appliance" on page 27
Wait until the programme ends, or wait
until 30 minutes after the end of the
programme before removing the utensils.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Set the door correctly with the aid of the
installation instructions so that the door
gap is at least 70 mm - 100 mm.
Plastic has a lower heat storage capacity
and therefore dries less well.
Separate cutlery if possible, prevent
contact points.
Arrange cutlery properly and separate if
possible.
On account of the "Condensation drying"
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
Advertisement
Table of Contents
