Sony DVCAM DSR-PDX10 Operating Instructions Manual page 88

Searching for a recording by index – INDEX SEARCH
If a tape has a blank portion between recorded portions
INDEX SEARCH may not work correctly.
If you mark an index onto an external input signal
"LINE" appears in the CH column.
The index of the recording start point when recorded from external audio
equipment
The index mark is not recorded in cassette memory. If you want to search for the index
point, see "Searching for the index point without using cassette memory" below.
Cassette memory
The tape with cassette memory can hold 135 index data. If you search among 136 or
more index data, see "Searching for the index point without using cassette memory"
below.
Searching for the index point without using cassette memory
(1) Set the POWER switch to VCR.
(2) Press MENU, then turn the SEL/PUSH EXEC dial to set CM SEARCH in
(3) Press SEARCH MODE on the Remote Commander repeatedly until the INDEX
(4) Press .
To stop searching
Press x.
88
OFF, then press the dial.
SEARCH indicator appears.
The indicator changes as follows:
INDEX SEARCH t DATE SEARCH t PHOTO SEARCH
(no indicator)
on the Remote Commander to search for the previous index point
or press > on the Remote Commander to search for the next index point.
Your camcorder automatically starts playback at the selected index point. Each
time you press or >
.
index point.
, your camcorder searches for the previous or next
PHOTO SCAN
to