Table of Contents
Advertisement
NLTroubleshooting
Malfunction
and program
broken.
Condensation water in it
condensation water tank
voir, although the water
drain hose is connected
locks.
Program does not start.
The program duration
changes during
drying.
Pump sound.
Buzzing sound.
Drying time is too long.
52
Cause and Troubleshooting
Make sure that the water drain hose is not kinked or
1.
trapped.
Lay the water drain hose without kinks.
2.
Water drain hose is not connected correctly.
Make sure that the water drain hose is correctly
▶
connected.
→ "Connect the water drain hose", page 14
Water drain hose is clogged.
Flush the water drain hose with tap water.
▶
The filter in the condensation tank is dirty.
→
"Clean the filter in the condensation tank.",
▶
page 49 .
The device uses condensed water for automatic self-
cleaning.
No error - no action required.
▶
Water drain hose is not connected correctly.
Make sure that the water drain hose is correctly
▶
connected.
→ "Connect the water drain hose", page 14
Child lock is activated.
→
"Deactivate childproof lock", page 38
▶
was not pressed.
Press .
▶
No program set.
→ "Set program", page 34 .
1.
→ "Starting the program", page 35 .
2.
The program sequence is optimized electronically. This
may lead to changes in the program duration.
No error - no action required.
▶
Condensation water pump active.
No error - normal operating noise.
▶
Compressor vent active.
No error - normal operating noise.
▶
Fluff filter is dirty.
→ "Clean the fluff filter", page 36
▶
Ambient temperature is higher than 30°C.
Make sure the ambient temperature is below 30°C.
▶
Advertisement
Table of Contents
