Bosch WQB245A5NL User Manual And Installation Instructions page 47

Table of Contents

Advertisement

Start intensive device care
Requirements
¡The appliance care is pre-
reid.
→ "Preparing device care", page
45
¡The device care has been called up
pen.
→ "Call up device care", page 45
Press
1.
aThe display shows alternately
"CP2" and the program duration.
2. ATTENTION!An incorrect dosage of
fabric softeners, detergents, care
products and cleaning agents can
affect the operation of the
appliance.
Follow the manufacturer's dosing
recommendations.
Place a bottle of appliance care
product and approx. 1.5 liters of
warm tap water in the condensation
container.
Hold the filled condensed water
container horizontally so that no
liquid escapes.
Slide the condensed water container
3.
into the device until it clicks into
place.
On
to press.
4.
aThe device care starts and there
sounds a signal.
aThe device pauses after approx. 3 hours
the appliance care and the
remaining program duration is
shown in the display.
Pull out the condensed water
5.
container horizontally and empty
it.
Pour approx. 1.5 liters of warm tap water
6.
into the condensed water container.
.
Carefully turn the condensed
7.
water container horizontally and
empty it to rinse out the
appliance care product residues.
Resume intensive device care
Pour approx. 1.5 liters of warm tap water
1.
into the condensed water container.
Hold the filled condensed water
container horizontally so that no
liquid escapes.
Slide the condensed water container
2.
into the device until it clicks into
place.
On
to press.
3.
aDevice care is restarted
barrel.
aAfter completion of the device
care, the display shows "End"
and a signal sounds.
Pull out the condensed water
4.
container horizontally and empty
it.
When you drain the condensed water
5.
through the drain hose:
Remove the stopper at the bottom
of the condensed water container.
Place the stopper in the recess
at the top of the condensed
water container.
Slide the condensed water container
6.
into the device until it clicks into
place.
Put the device in standby mode.
7.
→ "Putting the device to sleep
(standby mode)", page 36
Device careNL
47

Advertisement

Table of Contents
loading

Table of Contents