Table of Contents
Advertisement
Throttle / Choke Control
The throttle control lever is located on the left fender of the
tractor seated in the operator's position, see Figure 4-1. This lever
controls the speed of the engine, as well as the choke when it
is pushed all the way forward. When set in a given position, the
throttle will maintain a uniform engine speed.
IMPORTANT:
When operating the tractor with the cutting deck
engaged, be certain that the throttle lever is always in the FAST
(rabbit) position.
Moving the throttle lever all the way forward activates the
engine's choke control. See Figure 4-2. Activating the choke
control closes the choke plate on the carburetor and aids in
starting the engine.
Refer to Starting The Engine in the Operation section of this
manual for detailed starting instructions.
Ignition Switch Module
The ignition switch module is located on the left fender of the
tractor seated in the operator's position, adjacent to the Throttle/
Choke Control. To start the engine, insert the key into the ignition
switch module and turn clockwise to the START position. Release
the key into the NORMAL MOWING MODE position once the
engine has fired.
To stop the engine, turn the ignition key counterclockwise to the
OFF position. See Figure 4-3.
WARNING!
unattended. Always disengage PTO, move shift lever
into neutral position, set parking brake, stop engine
and remove key to prevent unintended starting.
IMPORTANT:
Prior to operating the tractor, refer to both Safety
Interlock Switches and Starting The Engine in the Operation
section of this manual for detailed instructions regarding the
Ignition Switch Module and operating the tractor in REVERSE
CAUTION MODE.
14
S
4— c
ection
ontrolS
FAST
SL OW
Figure 4-2
Never leave a running machine
& F
eatureS
Reverse
Caution Mode
Stop Position
Figure 4-3
Clutch-Brake Pedal
The clutch-brake pedal is located on the left side of the lawn
tractor, along the running board. Depress the clutch-brake pedal
part way down when slowing the tractor by changing speeds
(Refer to Speed Control Lever). Depress the pedal all the way down
to engage the disc brake and bring the tractor to a complete stop.
NOTE: The clutch-brake pedal must be completely depressed
to start the engine. Refer to Safety Interlock Switches in the
Operation section of this manual.
Shift Lever
The shift lever is located on the control panel just below the seat,
in the center of the tractor. It has three positions, FORWARD,
NEUTRAL and REVERSE. The brake pedal must be completely
depressed and the tractor must not be in motion when moving
the shift lever. See Figure 4-4.
IMPORTANT:
Never force the shift lever. Doing so may result in
serious damage to the tractor's transmission.
Figure 4-4
Normal
Mowing
Start
Position
Advertisement
Table of Contents
