Fisher & Paykel CMOTTK30 Installation Instructions

MODEL CMOTTK30 CONVECTION MICROWAVE TRIM KIT
INSTALLATION INSTRUCTIONS
Before you begin, read these instructions completely and carefully.
Getting Started
Remove packaging
Contents
Part Description
Trim Assembly
Base
Rear Duct
Forward Duct
Foam Tape
Mounting Bracket (L/R)
Sheet Metal Screws
Before installing trim kit, install the convection duct as follows:
1. Insert the rear section of the duct into the forward section of the duct and install 4 screws
supplied (Fig. 01).
2. Install foam tape on 2 anges of the rear section of the duct (Fig. 02).
3. Remove and retain the 2 top screws, left and right, located at the rear vertical edges
of the Microwave (Fig. 03).
4. Place the duct on top of the Microwave and reinsert the 2 screws removed in Step 3 (Fig. 04).
4 Screws
Fig. 01
Fig. 03
Tools Required
Qty
1/8" Drill
#2 Phillip Screwdriver
1
1
1
1
2 ft
2
14
Foam Tape
Foam
Tape
Fig. 02
Fig. 04