Majestic Meridian MER42MN Owner's Manual page 15

Removing Fixed Glass Assembly
• Pull the four glass assembly latches away from the tabs
on the glass frame. Remove glass assembly from the
appliance. See Figure 4.1.
• Clean glass with a non-abrasive, non-ammonia based,
commercially available gas fireplace glass cleaner
- Light deposits: Use a soft cloth with soap and water
- Heavy deposits: Use commercial fireplace glass
cleaner (consult with your dealer)
Replacing Fixed Glass Assembly
• Replace the glass assembly on the appliance. Hold glass
in place with one hand. Use the other hand to pull out
and latch the four glass assembly latches onto the glass
frame tabs.
• Inspect and operate all glass latches to ensure they
move freely and no obstructions are present.
• Reinstall decorative barrier front.
.
Majestic • MER36MN, MER42MN Owner's Manual • 2599-981 Rev. B • 5/23
Decorative Barrier Fronts
Frequency: Annually
By: Homeowner
Tools needed: Protective gloves, stable work surface
• Assess condition of screen and replace as necessary.
• Inspect for scratches, dents or other damage and repair
as necessary.
• Check that air intake and discharge areas are not
blocked.
• Vacuum and dust surfaces.
Optional Remote Control
Frequency: Seasonally
By: Homeowner
Tools needed: Replacement batteries and remote con-
trol instructions.
• Locate remote control transmitter and receiver.
• Verify operation of remote. Refer to remote control
operation instructions for proper calibration and setup
procedure.
• Replace batteries as needed in remote transmitters and
battery-powered receivers.
• Place remote control out of reach of children.
If not using your fireplace for an extended period of time
(summer months, vacations/trips, etc), to prevent unin-
tended operation:
• Remove batteries from remote controls.
• Unplug 6 volt adapter plug.
Termination Cap
Frequency: Seasonally
By: Homeowner
Tools needed: Protective gloves and safety glasses.
• Inspect exposed venting and termination cap for block-
age or obstruction such as plants, bird nests, leaves,
snow, debris, etc.
• Verify termination cap clearance to subsequent construc-
tion (building additions, decks, fences, or sheds).
• Inspect for corrosion or separation.
15