Assembling And Unfolding The Handle - Toro Super Recycler Operator's Manual

1. Warning—read the Operator's Manual.
2. Thrown object hazard—keep bystanders a
safe distance from the machine.
Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.
1. Assembling and Unfolding
the Handle
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
•
Do not damage the cables when assembling and
unfolding the handle. Ensure that you do not get
the cables caught between the handle halves and
that they run to the inside of the handles.
•
If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the upper handle knobs and bolts from the
upper handle ends.
2. Carefully move the upper handle forward and place the
ends over the lower handle so they are in line and nest
together; (Figure 3).
104-7909
3. Thrown object hazard, mower—keep the
deector in place.
4. Cutting/dismemberment hazard of hand or
foot, mower blade—stay away from moving
parts.
Figure 3
3. Install the bolts and upper handle knobs with the knobs
on the outside of the handle, tightening the knobs as
tight as you can (Figure 4).
Figure 4
4. Rotate the handle rearward (Figure 5).
4
5. Cutting/dismemberment hazard of hand
or foot, mower blade—do not operate up
and down slopes; operate side to side on
slopes; stop the engine before leaving the
operating position; and look behind you
when backing.