Table of Contents
Related Manuals for Siemens iQ700 ER9A6SD70A/41
Summary of Contents for Siemens iQ700 ER9A6SD70A/41
- Page 1 Built-in gas hob ER9A.SD7.A User manual and installation instructions Register your product on My Siemens and discover exclusive ser- vices and offers. siemens-home.bsh-group.com/welcome The future moving in. Siemens Home Appliances...
- Page 2 ER9A.SD7.A Component Pan support Control knobs Economy burner with an output of up to 1,10 kW Standard-output burner with an output of up to 1,90 kW High-output burner with an output of up to 2,80 kW Dual-wok multi-crown burner with an output of up to 6,10 kW The images shown in these instructions are for guid- ance only.
-
Page 3: Table Of Contents
Safety en Futher information and explanations are available online: Table of contents 1.2 Intended use The appliance can only be used safely if it is INFORMATION FOR USE correctly installed according to the safety in- structions. The installer is responsible for en- Safety .............. 3 suring that the appliance works perfectly at its 1.4 Safe installation .......... 4... -
Page 4: Safety
en Safety 1.4 Safe installation 1.5 Safe use Follow these safety instructions when in- WARNING ‒ Risk of explosion! stalling the appliance. Escaping gas may cause an explosion. WHAT ¡ Read the installation instructions carefully. TO DO IF YOU SMELL GAS OR IF THERE → "Installation instructions", Page 6 ARE FAULTS IN THE GAS INSTALLATION ¡... - Page 5 Safety en Escaping gas may ignite. WARNING ‒ Risk of poisoning! ▶ If the burner does not ignite after Using the gas cooking appliance leads to a 10 seconds, turn the control knob to the build-up of heat, moisture and combustion "Off" position and open the door or window products in the room where the appliance is in the room.
- Page 6 en Installation instructions ▶ Never pull on the power cord to unplug the connect the appliance from the power sup- appliance. Always unplug the appliance at ply. ▶ Shut off the gas supply. the mains. ▶ If the appliance or the power cord is dam- ▶...
- Page 7 Installation instructions en ¡ Seal the cut surfaces of wooden work surfaces with ¡ Height of the pan support above the worktop sur- a special glue seal to protect them from moisture. face: up to 60 mm. ¡ Any adjoining vertical wall surface situated within 200 mm from the edge of any cooktop burner must be a suitable non-combustible material for the entire length of the cooktop, in accordance with clause...
- Page 8 en Installation instructions 2.5 Positioning the appliance ¡ This appliance is connected to the mains (240 VAC) by means of the connecting lead. The connecting Note: Do not remove the adhesive seal fitted on the lead must be fixed to the kitchen unit to prevent it lower edge of the cooktop.
- Page 9 Installation instructions en ¡ Position of the inlet connection ¡ Connect with flexible hose. The hose assembly must comply with AS/NZS 1869, 10 mm ID, class B or D, no more than 1.2 m long and installed in accord- ance with AS/NZS 5601.1. Note: If installing with a hose assembly: ¡...
- Page 10 en Installation instructions Removing the upper part of the appliance (glass ATTENTION! plate with cut-out profiles) The circuit board can be damaged by improper hand- ling. Remove the pan supports, burner caps, distributors ▶ Handle the circuit board carefully. and rotary knobs. ▶...
- Page 11 Installation instructions en Replacing the injectors Set the spacing of the adjustment sleeve for the air supply to dimension Z, as shown in the table. ▶ Replace the nozzles using the appropriate wrench → "Injectors", Page 10 and tighten them carefully to guarantee the seal. Tighten the fastening screw.
-
Page 12: Preventing Material Damage
en Preventing material damage Checking if equipment is working Remove the sleeve. Check that turning the rotary knob between the pos- ition for maximum power and the position for min- imum power does not cause the burner to go out or result in backfire. -
Page 13: Environmental Protection And Saving En- Ergy
Environmental protection and saving energy en 4 Environmental protection and saving energy 4.1 Saving energy Use a glass lid. ¡ You can see into the pan through a glass lid If you follow these instructions, your appliance will use without having to lift it. less energy. -
Page 14: Accessories
Accessories vary from one appliance to another. When purchasing accessories, always quote the exact product number (E no.) of your appliance. → Page 19... -
Page 15: Basic Operation
Basic operation en 7 Basic operation 7.1 Igniting a gas burner ¡ The burner holes and grooves must be clean to en- sure a correct flame. The cooktop has automatic ignition of the burners. → "Cleaning the burners", Page 17 WARNING ‒ Risk of fire! 7.2 Safety system Escaping gas may ignite. -
Page 16: Recommended Settings For Cooking
en Recommended settings for cooking 8.2 Using cookware Do not use deformed Deformed cookware is cookware. Only use cook- not stable on the cooktop The selection and positioning of the cookware affects ware with a thick, flat and may tip over. the safety and energy efficiency of your appliance. base. -
Page 17: Troubleshooting
Troubleshooting en 10.2 Cleaning the appliance Completely dry the appliance. If there are water droplets or damp areas at the start of cooking, this ATTENTION! may damage the enamel. When the control knob is removed while cleaning the Insert the burner parts. Ensure that the burner caps appliance, humidity may get in and damage the interior are correctly positioned on the flame spreader. -
Page 18: Service
en Service Fault Cause and troubleshooting Automatic ignition is The burner parts are positioned incorrectly. not working. ▶ Correctly position the burner parts. The appliance is not earthed or has not been connected correctly, or the earth cable is damaged. ▶ Contact an electrician. -
Page 19: Customer Service
Customer Service en 13 Customer Service 13.1 Product number (E-Nr.) and production Detailed information on the warranty period and terms of warranty in your country is available from our after- number (FD) sales service, your retailer or on our website. You can find the product number (E-Nr.) and the pro- If you contact Customer Service, you will require the duction number (FD) on the appliance's rating plate. - Page 20 BSH Hausgeräte GmbH Carl-Wery-Straße 34 81739 München, GERMANY siemens-home.bsh-group.com Manufactured by BSH Hausgeräte GmbH under the trademark licence of Siemens AG *8001262291* 8001262291 (021201)