Sima GoDVD! CT-2 User Manual page 4

Operation
1. Connect the GoDVD unit as shown on page 3.
2. Select the PAL/NTSC output format by setting the PAL/NTSC output switch
to the desired setting. Note: The unit will automatically detect whether the
input is PAL or NTSC, however you must select the desired output format.
For use on U.S. televisions, VCRs and DVDs, set the output format
switch to NTSC.
3. Select the appropriate input by pressing the Input select switch. Green
indicator light signifies Composite signal. Orange indicator light signifies S-
video input signal.
4. Select the desired video enhancement mode by pressing the Video
Enhancement button. The button cycles between four enhancement
modes as follows:
Pressing the button four times begins the cycle again.
5. The LED indicator light shows which Input format and Enhancement mode
are selected. For example, a steady green light means you have selected a
composite input signal and will output in the Normal video mode. An
orange blinking light indicates an S-video input signal with one of three
enhancement modes. Use the steady indicator light as a fixed point to
determine the desired enhancement mode. Review the chart below to
determine the correct setting. If unsure which video enhancement mode is
selected, look at your video monitor while toggling through the options.
6. Select A/V input on your recording VCR or DVD and press RECORD.
7. Then press PLAY on your playback device.
Specifications
Note: VHS and DVD media are produced in more than one video format.
In the United States, the NTSC format is used. In Europe, the PAL
format is used. GoDVD! automatically detects the input format, however,
you must select the output format.
NTSC & PAL - GoDVD! converts NTSC to PAL and PAL to NTSC video
formats. To output in NTSC, slide the switch located on the OUTPUT
panel to the right. To output in PAL, slide the switch located on the
OUTPUT panel to the left.
INPUT
NTSC3.58 / NTSC4.43 / PAL / PAL M / PAL N / SECAM auto detection.
Input Connectors
Composite Video (RCA jack) x 1 / S-video (mini-din) x 1
Note: input selection switch toggles between composite and s-video input source.
OUTPUT
NTSC (Fsc=3.58 MHz) / PAL (Fsc =4.43 MHz)
Output Connectors
Composite Video (RCA jack) x 1 / S-video (mini-din) x 1
Power: DC 7.5V 500mA
Dimensions: 4.5"(W) x 2.5"(L) x .75"(H)