Troubleshooting; Connection Diagram - Sima GoDVD! CT-2 User Manual

Troubleshooting

Possible Solutions
•
Device does not
Press Input select switch to toggle between composite
operate
and s-video inputs.
•
Has correct mode (AV, Line, Tuner, etc.) been set on the
VCR or DVD
•
Correct connecting cable?
•
Have the RCA cables been mixed up at the input and
output of the VCR/DVD?
•
Is the Power light on? If not, there is no power.
No picture
•
Is the connecting cable of the plug-in adapter
damaged?
•
TV does not support 50/60 Hz scan rates.
Picture rolling
GoDVD! will not perform the following functions:
1. Allow you to play a PAL DVD or video tape on a NTSC player. (and
visa versa)
2. Allow you to play a PAL DVD or video tape on an NTSC TV that
supports only 60 Hz scan.
3. Allow you to copy an NTSC DVD or video tape to an NTSC DVD
recorder or VCR in the PAL format to send over seas, unless the
recorder supports both formats.
Congratulations on your purchase of Sima's GoDVD! (Model CT-2) This
package includes: (1) Go-DVD! - Model CT-2, (1) RCA style Video Cable
(1) 7.5V, 500 mA AC adapter and This Instruction Manual
Connection: GoDVD! should be connected between your playback VCR,
DVD or camcorder and the recording VCR or DVD as shown below.
Note: Regardless of which input is used, both outputs continuously deliver
an output signal. The unit will automatically detect whether the video input is
in NTSC (USA) or PAL (Europe) format. The output format is determined by
the setting of the PAL/NTSC output switch. (See diagram below)
Only the video cables are to be connected to GoDVD!. Audio cables should be
connected directly between the playback and recording units. With Hi-8 or S-
VHS capability, connect your S-video cables to GoDVD!.