Panasonic ES-RT37 Operating Instructions Manual page 12

►Trimming the edge of beard
Cut your beard gradually
with the power switch facing
opposite side of your skin,
taking care not to cut too
much.
Using the comb attachment
Note
Apply the oil to the trimmer before and after each use. (See
page 14.)
Failure to apply the oil may cause the following problems due to
rust, wear or burn out.
- The trimmer has become blunt.
- Shorter operating time.
- Louder sound.
Make sure that the shaver is turned off.
1
1
Mount the comb
attachment to the main
body until it clicks.
• Press and hold the comb
attachment release buttons to
remove.
2
2
Slide the trimmer handle
up until it clicks.
12
ES-RT77_67_47_37_US.indb 12
3
3
While pressing and
holding the trimming
height switch button, move
the comb vertically to the
desired trimming length
(between 1 mm (1/32˝) and
7 mm (9/32˝)).
ES-RT77/ES-RT47
• Actual hair length will be a little
4
4
Lightly push the comb
attachment to ensure that
it has locked into place.
5
5
Turn the shaver on, bring the comb of the
comb attachment into contact with the skin,
and cut the beard by moving the trimmer back
against the flow of the beard.
Trimming
mm 1.0 2.5 4.0 5.5 7.0
height
inch 1/32 3/32 5/32 7/32 9/32
(approx.)
Indicator 1.0 2.5 4.0 5.5 7.0
longer than the height you set.
2016/03/07 14:34:08