Table of Contents
Advertisement
U5303A Front Panel Features
Front Panel Connectors
Connector
TRG IN
IN 1, 2
JTAG
TRG OUT
I/O 1, 2, 3
CLK IN
REF IN
Front Panel LEDs
Indicator
DPU
STATUS
If warning or error status is observed, please try the following steps:
Power-cycle the chassis (If using a PCIe interface to external PC, observe the power sequence require-
l
ments)
If the error persists please contact Agilent technical support
l
Agilent U5303A Startup Guide
Type
Description
MMCX External trigger input, 50 Ω DC terminated, ±5 V range.
The analog signal inputs, which are DC-coupled and 50 Ω terminated. The
input full scale ranges are selectable:
SMA
Range
1 V
2 V
Micro
Provides connection to the DPU for use with the U5340A FPGA Development
USB
Kit.
MMCX Trigger Out signal. User selectable from several functions.
MMCX User configurable Input / Output signal. 3.3 V CMOS and TTL compatible.
External clock input. AC coupled and 50 Ω terminated, signal level: +5 to +15
MMCX
dBm. Please refer to datasheet for details.
External reference clock input, AC coupled and 50 Ω terminated. It can accept
MMCX
a 100 MHz signal from -3 to +3 dBm.
Purpose
Color
DPU status
Module status
Maximum Input
3 Vrms, ±3.6 Vpk
4.3 Vrms, ± 6.3 Vpk
State
Meaning
Off
DPU is not configured
Green, blinking
Module initialization in progress
Green
Module OK (firmware not yet loaded)
White
DPU firmware loaded (ready)
White, blinking
Firmware initialization in progress
Green, blinking
Module initialization in progress
Yellow, blinking
Warning
Red, blinking
Error
Green
OK (ready)
Step 4: Install the Module
15
Advertisement
Table of Contents
