Supply; Hoses And Cable Lengths; Water Supply Hose - Panasonic NA-107VC6 Operating Instructions Manual

Connecting Hoses and Power Supply
Follow the instructions in this section to prevent water leaks. If you are unsure, ask a service
agent to connect the hoses.

Hoses and cable lengths

Left side connections
~ 100 cm

Water supply hose

Caution
- Do NOT connect the water supply
hose to a combination tap.
- Do NOT twist, squash, modify, or
cut the hose.
- Optimum mains water pressure is 0.1 -
1.0 MPa. If the water pressure exceeds
this value, install a pressure reducing
valve.
- Waterflow from the tap should be more
than 5 L/min.
Connecting the water supply hose
1. Attach one end of the hose to
the water inlet on the back of the
appliance and tighten the joint by
hand.
38 - Installation Instructions
NA-107VC6_WHK_Eng.indb 38
~ 95 cm
~ 145 cm
Right side connections
~ 140 cm
~ 95 cm
~ 155 cm
2. Attach the other end of the hose to
the tap and tighten it the same way.
- Standard hose
Make sure the
filter is inside
the hose.
- Hose with water-supply valve
3/4"
min. 10 mm
3. Open the tap slowly and make sure
that there are no leaks around the
joints.
The joints are subject to water pressure.
3/4"
min. 10 mm
2018-8-1 15:03:18