Direct Call - Siemens CX70 Operating Manual

HTTP profile
The phone default setting varies
from service provider to service pro-
vider. Consult your service provider
or go to this address in the Internet
for more information
www.siemens-mobile.com/
mobilescustomercare
Authentication
Activate or deactivate encrypted
WAP dial-up (CSD connections only).
Fax/data
Send voice/fax
Set this function on the phone before
transmission so that you can switch
from voice mode to fax mode.
Rec. voice/fax
Start the required communication
program on your PC and select the
function on the phone during the call
(the PC will take over the connec-
tion).
Rec fax/data
The call is signalled by a special ring-
tone and the type of call (fax or data)
is displayed. Now start the commu-
nication program in your PC to
receive the fax/data.
Security
¢
C
¢
Auto key lock
If activated, the keypad is locked
automatically if no key has been
pressed for one minute in standby
mode. This prevents the phone from
being used accidentally. However,
you can still be called and you can
still make an emergency call.
Additional information
b
Block/unblock in standby mode. In each
case:
#

Direct call

Only one phone number can be
dialled. The required phone code
(4 to 8 digits) is set by you and
entered at the first security setting.
b
#
Only
‚
Restrict calls to SIM-protected num-
bers in the Phonebook.
Setup
¢
Security
T
Select function.
Press and hold
To switch off, press and
hold, then enter the tele-
phone code.
47
b