Clear Sim Card Barring; Preventing Accidental Activation; Dialling With Number Keys - Siemens AX72 User Manual

When charging is in progress
displayed.
Charging time
An empty battery is fully charged after
about 2 hours. Charging is only possible
within a temperature range of
+5 °C to +40 °C. If the temperature ris-
es/falls 5 °C above/below this, the charge
symbol flashes a warning. The mains volt-
age specified on the power supply unit
must not be exceeded (Operating time,
p. 12).
Only use the power supply unit provided!
Display while in service
Charge level display during operation
a d g
(empty - full):
A beep sounds when the battery is nearly
empty. The charge level of the battery is
only displayed correctly after an uninter-
rupted charging/discharging cycle. You
should therefore not remove the battery
unnecessarily and where possible not
terminate the charging process early.
Security
m
¢ ¢
Security
§Menu§
¢
Select function.
The phone and SIM card are protected
against misuse by several security codes.
Keep these confidential numbers in a safe
place where you can access them again if
required.
Codes
PIN control
You can stop the PIN prompt being
activated when the phone is switched on,
but you then risk unauthorised use of the
phone.
Press §Change§ . Enter PIN and confirm
with .
§OK§
Change PIN
You can change the PIN to any 4- to 8-digit
number you find easier to remember.
h
is
.
4
Change PIN2
(Display only if PIN2 is available). Proceed
as with Change PIN.
Change phonecode
You define the phone code (4-8 digits)
when you call up a protected function for
the first time. It is then valid for all phone-
code protected functions.

Clear SIM card barring

If the PIN is entered incorrectly three
times, the SIM card is barred. Enter the
PUK (MASTER PIN), provided by your serv-
ice provider with the SIM card, according
to instructions. If the PUK (MASTER PIN)
has been lost, please contact your service
provider.

Preventing accidental activation

Even if PIN control is deactivated confirma-
tion is required to switch on the phone.
This prevents the phone from being
switched on accidentally, e. g. when car-
ried in a pocket or whilst you are on an
aircraft.
Press and hold the On/Off/End key
and confirm with
es on.
Calling

Dialling with number keys

The phone must be switched on (standby
mode). Dial number (always with area
code, if necessary with international dial-
ling code). To dial international dialling
code press and hold
played. Press
§Country§
Short press to clear the last digit, a
§Clear§
long press clears the entire phone
number. To dial press the Call key
B
. The phone switch-
§OK§
0
until a "+" is dis-
and select country.
A
.