Tools Needed; Mounting Considerations - Garmin GPSMAP 9000 Series Installation Instructions Manual

Tools Needed

• Drill and drill bits
◦ 3.2 mm (
1
/ in.) drill bit, if using wood screws
8
◦ 3.6 mm ( 9
/ in.) drill bit, if using the nut plate
64
◦ 7.2 mm ( 9
/ in.) drill bit, if using the nut plate
32
• #2 Phillips screwdriver
• Jigsaw or rotary tool
• File and sandpaper
• Marine sealant (recommended)

Mounting Considerations

This device should be mounted in a location that is not exposed to extreme temperatures or conditions. The
temperature range for this device is listed in the product specifications. Extended exposure to temperatures
exceeding the specified temperature range, in storage or operating conditions, may cause device failure.
Extreme-temperature-induced damage and related consequences are not covered by the warranty.
Using the included hardware and template, you can flush mount the chartplotter in the dashboard.
When selecting a mounting location, observe these considerations.
• You should mount the chartplotter to provide an optimal viewing angle as you operate your boat.
• You must select a location that is strong enough to support the weight of the chartplotter and protect it from
excessive vibration or shock.
• You should select a location that allows for easy access to all interfaces, such as the keypad, touchscreen,
and card reader, if applicable.
• To avoid interference with a magnetic compass, you must not mount the chartplotter closer to a compass
than the compass-safe distance value listed in the product specifications.
• You must select a location that allows room for the routing and connection of all cables.
• If the mounting location is in direct sunlight and in a horizontal orientation, ensure that the installation
location meets as many of the following criteria as possible:
◦ Sufficient air flow
◦ Proper ventilation
◦ Cooling source on the front and rear of the chartplotter
◦ Method to shade the display using a canopy, window tint, or shroud
NOTE: If possible, you should meet all of these criteria when installing the chartplotter.
NOTICE
3