Sherwood NewCastle R-903 Operating Instructions Manual page 45

SETUP
[ 1 ]
MEMORY
Surround mode
: not available when the
input signal is 96kHz PCM
or headphone is used.
Speaker setup mode
("FL - CL - SL")
Channel level trim mode
("FL 0")
Preset channel level mode
[1]
("P CALL")
LFE channel level mode
("DD L")
Tone mode
("BASS" or "TONE OFF")
: available only when STEREO is
selected during that analog or PCM
signal is input.
Dynamic range mode
("DYNR 0.0")
: available only when the input
signal is Dolby Digital.
Dolby Pro Logic II Music
Parameter mode
("PANO OFF")
: available only when the
current surroudn mode is
Dolby Pro Logic II Music.
DECODING
[ 2 ]
TUNE MODE
STEREO(or 2 CH DOWNMIX) mode
( ): Possible when the digital signals from the DTS
or Dolby Digital program sources are being
input.
FL-CL-SL SUR B - L SUB W-Y FRONT 3.0(m)
CFREQ80 NARROW SURROUND 3.0(m) CENTER 3.0(m)
FL C FR SR SB
SW SL
[3] Confirm your decision.
DD L DTS L MP L
BASS TRBL TONE ON
• While displaying "TONE OFF", you cannot
adjust the tone.
Ignore this step and skip to the step 3.
PANO OFF C-WID 0 DIMEN 0
44
ADJUST
[ 3 ]
TUNING/PRESET
Turn back to previous surrond mode and
select the desired surround mode.
(For details, refer to "Selecting the surround
mode" on page 24.)
Adjust the selected mode as desired.
(For details, refer to "Adjusting the speaker
settings" on page 19.)
Adjust the level of the selected channel as
desired.
(For details, refer to "Adjusting each
channel level" on page 25.)
[2] Select Preset Call or Preset Memory as
desired.
Adjust the level of the selected LFE channel
as desired.
(For details, refer to "Adjusting the LFE
channel level" on page 27.)
Adjust the tone as desired.
(For details, refer to "Adjusting the tone
(bass and treble)" on page 26.)
Select the desired setting.
(For details, refer to "compressing the
dynamic range(Dolby Digital sources only)"
on page 28.)
Adjust the selected parameter as desired.
(For details, refer to "Adjusting the Dolby
Pro Logic II Music parameters" on page 29.)