Advertisement
Install the tank lid and the seat. Use
the supplied hardware pack for seat.
Periodically check for leaks for several
days following the installation.
Connect the push button and flush
valve.
FILL FLOAT WITH
BALLAST
Test flush the toilet.
Check all connections for leakage for
several days.
Set the tank cover in place on the tank.
SYMPTOMS
1.Dual flush fail.
2. Fill valve continues to
run, allowing water to
enter tank.
3. Incorrect water level
height.
4. Long or noisy tank fill
cycle.
5. Poor flush.
6. Toilet overflows.
7. Toilet does not activate.
1195897-T01-C
Fig.#15
PROBABLE CAUSES
A. Push button do not touch seat.
A. Foreign particles lodged under the float valve
seal (located under fill valve cap).
B. Fill valve seal (located under float valve cap)
may be cracked or split.
C. Water leaking past flush ball.
D. Flapper can not fall automatically.
E. Flush valve flapper ball worn, dirty or
misaligned with flush valve seat; or seat
corroded so flapper will not seal.
A. Valve float cup does not contain enough water
to provide required ballast.
A. Plugged valve inlet or supply line.
A. Water level is too low.
B. Trapway or rim holes are obstructed.
C. Soil pipe or vent is obstructed.
D. Supply shut-off valve not fully open.
A. Toilet trapway is obstructed.
B. Soil pipe or vent is obstructed.
A. Push button is not connected to lift rod or
flush valve.
15
Fig.#16
16
A. Operate push button correctly.
A. Shut off water supply; remove fill valve cap
assembly by rotating 1/8 turn counterclockwise.
Cover uncapped lower valve unit with an
inverted cup (holding it to prevent overspray),
and turn water on and off a few times. Clean fill
valve seal surface (located under float valve
cap). Replace fill valve cap assembly by
engaging lugs and rotating 1/8 turn clockwise.
Turn water on. Install filter in supply line to
prevent recurring problems.
B. Replace seal.
C. Replace flush ball.
D. The belt is not smooth.
E. Inspect, clean and, if necessary, replace
flapper ball and/or seat.
A. During fill cycle, hold float under water a few
seconds to allow it to fill with water ballast.
A. Clean the filter of inlet valve.
A. Adjust tank water level.
B. Unclog trapway; clean rim holes.
C. Clear obstruction from soil pipe or vent.
D. Open supply shut-off valve.
A. Use plunger to unclog.
B. Clear obstruction from soil pipe or vent pipe.
A. Reconnect the push button.
-6-
CORRECTIVE ACTION
Advertisement
