Adjust Discharge Chute Deflector Lever; Adjust Discharge Chute; Adjust Speed Selector Lever - Ariens Sno-Tek 20 Operator's Manual

ADJUST DISCHARGE CHUTE

DEFLECTOR LEVER
Model 920402
See Figure 22.
If deflector does not stay in selected position,
tighten the nut under the control panel.
Figure 22
If deflector does not follow full range of travel:
1. Position deflector control in the rear-most
position.
2. Adjust nuts on chute cable. See
Figure 23.
• To adjust deflector lower, loosen lower
nut and tighten upper nut.
• To adjust deflector higher, loosen upper
nut and tighten lower nut.
1. Chute Cable
2. Upper Adjustment Nut
3. Lower Adjustment Nut
Figure 23
1
2
3
EN - 17
ADJUST DISCHARGE CHUTE
See Figure 24.
If discharge chute does not stay in selected
position, tighten nut on carriage bolt.
Figure 24
ADJUST SPEED SELECTOR
LEVER
See Figure 25.
1. Disconnect adjustment pivot pin from
speed selector arm. Save hardware for
reinstallation.
2. Position speed selector lever in fastest
forward position.
3. Turn speed selector arm down as far as it
will go.
4. Thread adjustment pivot pin along shift
rod until it aligns with the mating hole on
the speed selector arm, and then turn it
up the shift rod 7 turns. Insert pivot pin
into the hole.
5. Connect pivot pin to speed selector arm
with hardware removed in step 1 and
check forward and reverse speeds.
a. Start unit, position speed selector
lever in the first forward position and
engage traction drive clutch. Unit
should move forward.
b. Stop unit, position speed selector
lever in the first reverse position and
engage traction drive clutch. Unit
should move in reverse.
c. Stop unit. If unit does not travel
correctly, repeat adjustments.