DeWalt DXV34P-QT Manual page 19

English
Storage (Fig. A)
1.Empty the dust tank, refer to To Empty dust tank
instructions.
2.Clean the vacuum inside and outside. Refer to
Cleaning.
3.Clean or replace filters, refer to Filters.
4.Store the suction hose and the power cord as
shown in the Fig.A. Place the appliance in a dry
room and secure it from unauthorized use.
Optional Accessories
WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
E
product, use of such accessories with the appliance
could be hazardous.
To reduce the risk of injury, only D
recommended accessories should be used with this
product.
CLEANING
To keep your wet/dry vac looking its best, clean the
outside with a cloth dampened with warm water and
mild soap.
To clean the tank:
1.Dump out debris.
2.Wash tank thoroughly with warm water and mild
soap.
3.Wipe with dry cloth.
TROUBLESHOOTING
WARNING:
TO REDUCE THE RISK OF INJURY FROM
MOVING PARTS AND/OR ELECTRICAL SHOCK,
TURN POWER SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL OUTLET
BEFORE PERFORMING TROUBLESHOOTING
CHECKS.
Minor problems often can be fixed without calling
customer service.
WALT
E
be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
all local, state and federal guidance on general
cleaning practices.
17
PROBLEM
Check power cord, plugs and outlet.
Motor does not run
Ensure the on/off switch is in the
ON position ( I )
Remove blockages in the suction
nozzle, suction tube, suction hose
or filters.
Replace the paper or fleece bag.
Suction capacity
Check for proper installation of the
decreases
filters.
Clean or replace the filters.
Empty canister, refer to Empty
the tank under Operating.
instructions
Thermal overload has been tripped:
1.Turn the vacuum off and
Vacuum stops
disconnect vacuum cleaner from
running
power source.
2.Empty the canister, if needed.
3.Allow the unit to cool.
4.Plug the power cord into an
appropriate outlet and turn on/off
switch to the ON position ( I ) to
test.
Check for proper installation of the
filters.
Ensure filters are not damaged;
Dust comes out
replace if necessary.
while vacuuming
Ensure filter seals are in place and
are secure.
If the supply cord is damaged, it must
WARNING:
This product is NOT to beused for
WARNING:
tering of pathogens, for example COVID-19. Follow
TOOL GUARANTEE
3
YEAR
LIMITED
GUARANTEE
SOLUTION