Page 1
Operator’s manual T-Line Dust Extractor T7500, T10000 Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Kevmor Trade Supplies 11 Belmont Avenue, Belmont WA 6104 P: 08 9277 7177 E: sales@kevmor.com.au kevmor.com.au...
It is not suitable for picking up liquids. Husqvarna will not be held responsible if the dust extractor is used for other applications or been used in ways other than those outlined in this instruction manual.
1. SAFETY
I NSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: WARNING – To reduce the risk of fire, electric shock or injury: Cables damaged through crushing or splitting can be dangerous if used and should be replaced •...
Page 4
THERMAL PROTECTION The dust extractor is equipped with a safety thermal protector to prevent motor from overheating. • Should thermal protector activate, turn off machine, unplug power cord and check for full dust bag, vacuum hose clog or filter blockage. It may take up to 45 minutes for the thermal protector to reset. GROUNDING INSTRUCTION The dust extractor must be grounded.
Page 5
• MODEL
USCS
METRIC
T7500
Not
i ncluded
T10000
3"
t o
t wo
3 "
76mm
t o
t wo
7 6mm
If any of the above-mentioned parts are missing, please contact your local distributor or our sales representative.
T10000 Start and stop 3. FUNCTION
The machine is designed for vacuuming and separating dry, non-combustible dust with an explosion limit value of >0.1mg/m The dust extractor is started by the green button on the electrical cabinet, it is stopped by pressing the red button that is located directly below the start button.
Pull down the outside end and close it using a zip tie. All dust extractors can be used with original Husqvarna dust bags for single use. Also all models can be fitted with the longopac system.
Children should be supervised to ensure that they do not play with the appliance. 8. WARRANTY All Husqvarna devices and accessories have a 12-month factory warranty for material and manufacturing defects. The warranty extends to 36 months when returning the attached warranty slip. Do not attempt to repair the suction apparatus without the consent of the manufacturer.
9. PROBLEM
S OLVING The dust extractors are designed and manufactured for severe environments and tasks, but the user must note that the machine must be protected from knocks and blows. Filter, seals, attachments, and connections are carefully adapted and selected with regard to the operator’s work environment. Therefore, the operator and service personnel must treat the machine with care in order for it to work correctly for many years.